86 21... Removing centering pin from mounting bracket

NOTE: Exclusively for removal of pin, raise the hood in the GFP area. For raising, use a wooden block with a maximum width of 35 mm and a height of 45 mm. The length must be selected depending on the lifting platform securing point. Ensure the hood is secure on the blocks.

Position block (1) so that it is only located in area of sponge rubber seal (2).

Fig 1: Block (1) So That It Is Only Located In Area Of Sponge Rubber Seal (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Insert a mandrel into hole (1) of pin (2) and turn counterclockwise.

Fig 2: Insert A Mandrel Into Hole (1) Of Pin (2) And Turn Counterclockwise

Courtesy of BMW OF NORTH AMERICA, INC.