N54 Performance Power Kit With Boost Pressure Control Faults Stored (12 01 10)

Publication date: 2010-03-01
Reference number: 12 01 10

N54 PERFORMANCE POWER KIT WITH BOOST PRESSURE CONTROL FAULTS STORED

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI B 12 01 10, Date of Issue: March 2010

BMW:	E82, E88, E90, E92, and E93 with N54 and the BMW Performance Power Kit
GROUP:	12 - Engine Electrical Systems

SUBJECT

N54 Performance Power Kit with Boost Pressure Control Faults Stored

SITUATION

The engine warning is displayed and engine power is reduced. If this were to occur, both of the following boost pressure control faults would be stored in the DME:

30FE - boost pressure control system, boost pressure too-high

30FF - boost pressure control system, switch-off

CAUSE

DME software error

CORRECTION

This situation could affect all models with the BMW Performance Power Kit installed and a current vehicle integration level of E89X-09-12-512 or lower.

Program the vehicle using ISTA/P 2.37.0 or higher.

Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.

For information on programming and coding with ISTA/P, refer to CenterNet / Aftersales Portal / Service / Workshop Technology / Vehicle Programming.

WARRANTY INFORMATION

Covered under the terms of the BMW New Vehicle/SAV Limited Warranty, or any applicable Emissions Warranty.

WARRANTY INFORMATION

Defect Code:	10 42 31 59 00
Labor Operation:	Labor Allowance:	Description:
Refer to KSD2	Refer to KSD2	Programming/encoding control unit(s)