Check Control Message For Overheated Convertible Top Drive Motor (54 10 10)

Publication date: 2010-10-25
Reference number: 54 10 10

CHECK CONTROL MESSAGE FOR OVERHEATED CONVERTIBLE TOP DRIVE MOTOR

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI B54 10 10, Date of Issue: October 2010

BMW:	E88 (1 Series) up to June 14, 2010 production
GROUP:	Special Roofs

SUBJECT

Check Control Message for Overheated Convertible Top Drive Motor

SITUATION

Intermittently a CC (Check Control) message is displayed, indicating overheating of the convertible top drive motor.

CAUSE

The convertible top module (CVM) coding

PROCEDURE

Perform diagnostics with ISTA, and then code the CVM with ISTA/P 2.38.1 or greater.

WARRANTY INFORMATION

Covered under the terms of the BMW New Vehicle Limited Warranty.

Defect Code: 61 35 49 15 00

WARRANTY INFORMATION

Labor Operation:	Labor Allowance:	Description:
00 00 006*	Refer to KSD2	Perform vehicle test
61 00 710	Refer to KSD2	Program and Code with ISTA/P (w/o CAS)
61 00 720	Refer to KSD2	Program and Code with ISTA/P (with CAS)
Refer to KSD2	Refer to KSD2	Concluding work (initializations) as described in ISTA/P final report

*Main Work - Only one main labor operation (ending with 000-499) may appear on any claim or group of claims (warranty, maintenance or campaigns) that are generated from the same repair visit.

All other labor operations on the same line or other lines must be claimed using plus code labor operations (KSD2 labor operations that have a (+) prefix and the last three digits are 500 or a higher number).

In cases where ISTA requires the replacement of control modules or additional programming because certain control modules failed to program correctly, or just an initialization is required, print out the Measures Plan and/or Final Report and attach these reports to the RO in the vehicle file. This additional work should be claimed under the defect code listed in this bulletin, using the labor operation and labor allowance from the KSD2.