LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2007 >> Z4 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Electrical System - Repair - E90/E91, Z4 >> 00 Troubleshooting >> 12 00 ... Instructions for disconnecting and connecting battery >> Notes

12 00 ... Instructions for disconnecting and connecting battery: Notes

Observe Safety Instructions For Handling Vehicle Battery .

Before disconnecting battery: 

Turn off the ignition and other electrical loads/consumers to prevent sparking when reconnecting.

NOTE: If the ignition is not turned off when the battery is disconnected, fault memories may be set in some control units.
IMPORTANT:
  • There is a danger of mixing up battery leads: If the battery positive and negative leads are the same colour and you are in doubt, follow the polarity to the battery, then mark and cover the leads.
  • On vehicles with radio code: After disconnecting the battery, the radio code must be reentered. Therefore obtain the radio code card from the customer beforehand. Note stored stations and restore them after connecting the battery.
  • Stored settings of the on-board computer and clock will also be lost.
  • All available central keys must be recoded for cars with first generation infrared transmitter locking systems.

General notes on disconnecting battery: 

After connecting battery: 

IMPORTANT: After a power supply interruption some equipment is disabled and must be reactivated.

Likewise, individual settings are lost and must be activated.


Example:
Please refer to the Progman user documentation for further information on vehicle-specific activation.