86 10 ... Replacing Drawbar Members, Left and Right

Remove complete brake pull rod.

Removal of position light cable, refer to 86 10 ... REPLACING LICENSE PLATE LIGHT.

Release screws (1) on cross-member (2). Pull out crossmember (2) towards rear.

Installation:

Tightening Torque: 86 10 16AZ, see 86 10 PLATFORM .

Fig 1: Identifying Screws On Cross-Member

Courtesy of BMW OF NORTH AMERICA, INC.

Release countersunk head screws (1) and remove.

Installation:

Tightening Torque: 86 10 3AZ, see 86 10 PLATFORM .

Fig 2: Identifying Countersunk Head Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holder (1) and remove wiring harness (2) from drawbar member (3).

Fig 3: Identifying Cable Holder, Wiring Harness & Drawbar Member

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable (1) from position light housing (2). Pull out cable (1) through drawbar member aperture (3).

Fig 4: Identifying Cable, Housing & Drawbar Member Aperture

Courtesy of BMW OF NORTH AMERICA, INC.

Release all screws on cross-member (1) and remove crossmember (1).

If necessary, release screws on mounting brackets (2) and remove cross-members (3).

Installation:

Use new self-locking nuts.

Tightening Torque: 86 10 17AZ, see 86 10 PLATFORM .

Fig 5: Identifying Screws On Cross-Member

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolt (1). Grip nut from rear through assembly hole (2) in cross-member.

Installation:

Use new self-locking nuts.

Tightening Torque: 86 10 18AZ, see 86 10 PLATFORM .

Fig 6: Identifying Bolt & Assembly Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Tilt drawbar member (1) down in direction of arrow A and pull out towards rear in direction of arrow B.

Fig 7: Pulling Drawbar Member

Courtesy of BMW OF NORTH AMERICA, INC.