32 13 650 Removing And Installing/Replacing EH Converter For Servotronic
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Necessary Preliminary Tasks:
- Remove steering gear cover at side.
- If necessary, remove heat shield. See AUTOMATIC TRANSMISSION
Disconnect plug connection (1).
Unfasten screws (2).
Remove EH converter (3).
Installation:
Clean side return orifice with compressed air.
Align EH converter (3) to opening in power steering gear, press by hand into power steering gear up to stop, insert screws (2) and tighten down.
Tightening torque, refer to 32 13 12AZ in STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES .
After Installation:
- Fill and bleed hydraulic system. Refer to 32 13 006 BLEEDING POWER STEERING UNIT .
Version With Dynamic Drive:
- If necessary, carry out initial operation for Dynamic Drive. Refer to 37 10 001 INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE .