13 62 010 Removing And Installing/Replacing Differential Pressure Sensor (N62, N62TU)

Necessary preliminary tasks:

Read out fault memory of Digital Motor Electronics (DME) control unit; if necessary, work through test schedules
Switch off ignition

REFERENCE CHART

Work step	Note:
	Installation location: On rear side of intake air manifold.
Remove design cover.	E65/E66 only
Remove ACOUSTIC COVER .
Remove BOTH LOWER MICROFILTER HOUSING SECTIONS .	E60/E61/E63/E64 only
Remove engine compartment bulkhead.	E65/E66 only
Remove cover for ignition coils on left and right.
Unlock and disconnect following plug connections. Fuel rail, left and right, on cable duct Throttle-valve assembly Knock sensor, left and right All solenoid valves Both temperature sensors Oil-pressure switch Tank venting valve Alternator Valvetronic servomotor, left and right Pulse generator on exhaust and inlet camshafts, left and right Eccentric shaft sensor, left and right	Lines to oxygen sensors remain connected. Lines to electronics box remain connected.

Unfasten screws.

Take off holder (4).

Lay cable ducts to one side.

Fig 1: Locating Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Unfasten screws.

Pull differential pressure sensor (2) out of intake air manifold.

Fig 2: Locating Screws, Plug And Pressure Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Now clear the fault memory.