86 21... Installing Sponge Rubber Seal

NOTE:

Removing old sponge rubber seal: Pull off old sponge rubber seal. Remove remaining traces of adhesive with universal cleaner.

Sponge rubber seal runs along area marked gray (1).

Fig 1: Identifying Area Marked Gray

Courtesy of BMW OF NORTH AMERICA, INC.

Lay sponge rubber seal (1) in middle of hood contact surface (2).

Installation:

Degrease contact surface (2) with benzine and rub down with a dry cloth. Stick on sponge rubber seal (1) according to manufacturer's instructions. Position end face of seal (1) in a straight area.

Fig 2: Identifying Sponge Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.