66 53 ... Instructions For Adapting Adjustment Unit For Reversing Camera (CORGHI KDS Quick-Action Clamp)

The following operations should only be carried out when using the tool kit for calibrating the reversing camera for the first time.

NOTE: The operation is described for the left-hand side; proceed in the same way for the right-hand side.

Remove support plate (1) from spindle (2).

Replace spindle (2) by spindle (3).

Press support plate (1) on to spindle (3).

Fig 1: Identifying Support Plate & Spindle

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining clip (1).

Remove ball pin (2) from rod (3).

Fig 2: Identifying Retaining Clip, Ball Pin & Rod

Courtesy of BMW OF NORTH AMERICA, INC.

Fit new ball pin (1) on rod (2) and secure with retaining clip (3).

Fit ball pin (1) on CORGHI KDS quick-release clamp and secure.

Fig 3: Identifying Ball Pin, Rod & Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Remove all spacers (1) on cross bar (2).

NOTE: Follow the same procedure for calibrating the reversing camera.

Fig 4: Identifying Spacers & Cross Bar

Courtesy of BMW OF NORTH AMERICA, INC.