61 61 270 Removing and Installing Console For Windshield Wiper System Completely With Motor
Necessary preliminary tasks:
- Remove cowl panel cover.
- Remove tension strut on spring strut dome. . See 51 71 373 REMOVING AND INSTALLING/REPLACING TENSION STRUT ON SPRING STRUT DOME
- Remove fresh air duct. . See 64 31 053 REMOVING AND INSTALLING OR REPLACING FRESH AIR DUCT
IMPORTANT:
Before fitting windshield wiper arms, allow wiper motor to run into rest position.
Release screws (1).
Installation:
Tightening torque 61 61 15AZ . See 61 61 WINDSCREEN WIPERS
Remove cross-strut bearing block (2) in direction of arrow.
Unfasten plug connection (1) and disconnect.
Release screws (A5...A1).
Installation:
Insert screws (A1...A5) in specified sequence until hand - tight.
To tighten down screw (A2), if necessary move complete wiper console linkage (2) into reversal position.
Tighten down screws (A1...A5) in specified sequence to tightening torque 61 61 6AZ . See 61 61 WINDSCREEN WIPERS
Lever out complete wiper console (2) in direction of arrow.