61 35 015 Removing and installing (replacing) control unit for Car Access System
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection), refer to 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
Necessary preliminary tasks:
- Remove trim panel for pedal assembly, refer to 51 45 185 REMOVING AND INSTALLING/REPLACING TRIM FOR PEDAL ASSEMBLY .
Unfasten plug connection (2) and disconnect.
IMPORTANT:
Carefully unlock and disconnect associated plug connection for ribbon cable (1). Replace ribbon cable (1) if:
- plug connection for ribbon cable (1) is damaged
- control unit for Car Access System (3) is replaced
The ribbon cable leads to the ignition starter switch, refer to 61 31 020 REMOVING AND INSTALLING/REPLACING IGNITION STARTER SWITCH .
Release screw (4) and remove control unit for Car Access System (3) in direction of arrow.
Installation:
Feed guide (1) of control unit for Car Access System (2) correctly into associated mounting.
Replacement:
Carry out programming/coding, refer to DIAGNOSIS PROGRAMMING/CODING .
Version with independent heating:
Initialize all independent heating remote controls, refer to 64 12 ... INITIALIZING INDEPENDENT HEATING REMOTE CONTROL .