Working on Steering Column

Before performing any work on the steering column, it is required that the steering locking pin is engaged in the "centering" position. This prevents turning of the steering spindle during installation. If the steering spindle is turned, this will break the internal sensor connecting harness to the EPS Control Module. The connecting harness is located in the coil spring. The spring is installed in the servo unit housing.

When the lower steering spindle is disconnected from the steering gear, it is important when reinstalling to ensure that the center marking on the lower steering spindle is aligned with the center marking on the steering gear. The upper steering spindle and the steering gear are equipped with plastic lugs which determine the correct installation position of the lower steering spindle.