Check Control Message "Rollover Protection Fault" (72 03 05)
Publication date: 2005-06-01Reference number: 72 03 05
CHECK CONTROL MESSAGE "ROLLOVER PROTECTION FAULT"
TECHNICAL SERVICE BULLETIN
Reference Number(s): SI B 72 03 05, Date of Issue:
June 2005
| BMW: | E64 (6 Series) |
| GROUP: | 72 - Safety Restraint Systems |
SUBJECT
Check Control Message "Rollover Protection Fault"
SITUATION
The customer complains of check control message "Rollover Protection Fault" in CID (Central Information Display). Fault code 9425 (Serial cable to satellite, vehicle center) is stored in the SGM (Safety Gateway Module).
CAUSE
Software / Faulty wiring or connectors / Faulty SFZ (Vehicle Safety Satellite) / Faulty SGM.
CORRECTION
Follow the test plan in DIS. Correct any faults that are identified.
If fault frequency is (1), fault is not currently present, and no other faults are identified, then delete the fault code (do not replace parts).
WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle Limited Warranty.
Defect Code: Refer to KSD
Labor Operation: Refer to KSD