LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2000 >> 323Ci 2D Convertible, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Specifications & Procedures >> Wheel Alignment Procedures >> Camber Adjustment >> Rear (E53)

Rear (E53)

  1. Replace nut (1). Eccentric screw (2) must be located between stops (3). See Fig 1.
  2. Tighten down new nut (1) to specification. See E53  under TORQUE SPECIFICATIONS.
  3. Slacken nut (1) approximately 3/4 turn.
  4. Turn eccentric screw and adjust camber to specification. See E53  under WHEEL ALIGNMENT SPECIFICATIONS.
  5. Position eccentric screw between the stops (3). See Fig 1.
    6. CAUTION: If the nut is tightened down more than 4 times during adjustment, it must be replaced again. The self-locking effect becomes too slight.
  6. Tighten down nut to specification. See E53  under TORQUE SPECIFICATIONS.
Fig 1: Adjusting Camber (E53 Rear)
G00183268Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals