LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1993 >> 740i >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Recirculating Ball >> Removal & Installation >> Steering Gear >> Installation

Steering Gear: Installation

  1. To install, reverse removal procedure. Position steering gear and wheel in straight-ahead position. Align marks on pinion shaft shield and steering gear with steering shaft. If necessary, turn steering gear clockwise or counterclockwise against stop and then back by 1.7 turns until marks are aligned.
  2. Ensure pinch bolt is in groove of steering shaft. Replace banjo bolt sealing washers. Tighten all connections to specifications. Refer to the TORQUE SPECIFICATIONS  table. Fill system with NEW fluid. Bleed system.
scientia non olet · About LEMON Manuals