Overview - Data Bus On Board Diagnostic Interface
WARNING: This page is about a different car, the 2025 Audi SQ5 Sportback, 2025 Audi SQ5, 2025 Audi Q5 e, 2025 Audi Q5 Sportback, and 2025 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Protective Cover
- Replace after removing
- Sealing Washer
- Quantity: 2
- shared component with the protective cover
- Antenna Wire Connector
- Quantity: 2
- Connector
- For the Data Bus On Board Diagnostic Interface -J533- - High
- Connector
- For the Data Bus On Board Diagnostic Interface -J533- - High
- Data Bus On Board Diagnostic Interface -J533- - High
- with Telematics Emergency Battery
- Emergency Battery, Removing and Installing. Refer to appropriate service information 830Connected Gateway: Emergency Battery, Replacing.
- Removing and Installing. Refer to Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING .
- Always install with the protective cover
- Nut
- Quantity: 2
- There are different versions. Refer to the appropriate Electronic Parts Information (ETKA).
- Replace the self-locking nuts after removing.
- 5 Nm
- Data Bus On Board Diagnostic Interface -J533- - Low
- Removing and Installing. Refer to Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING .
- Always install with the protective cover
- Connector
- For the Data Bus On Board Diagnostic Interface -J533- - Low