Driver Assistance Systems Front Camera, Calibrating: Notes
There are two choices for calibrating:
The "complete alignment"
This procedure should be selected for the following activities if a wheel alignment and calibration/adjustment should be performed.
- The rear axle toe was adjusted.
- The vehicle suspension was changed, for example changing from standard to sport suspension.
The "quick access"
This procedure should be selected for the following activities if only the calibration/adjustment will be performed.
- The test plan in the Vehicle Diagnostic Tester requires a readjustment.
- The Driver Assistance Systems Front Camera -R242- was removed and installed or replaced.
- The bracket for the Driver Assistance Systems Front Camera -R242- was removed and installed or replaced.
- The lens was replaced (window heating faulty).
- The inside of the black cut-out was cleaned.
- The wire for the Driver Assistance Systems Front Camera -R242- was replaced.
- The connector for the Driver Assistance Systems Front Camera -R242- was touched.
- The windshield was removed and installed or replaced.
Both procedures are programmed in the wheel alignment computer. The respective procedure is performed automatically. It is only necessary to select the appropriate program for the procedure that will be performed.
If only the front camera should be calibrated/adjusted, then the "quick access" mode must be selected on the wheel alignment computer.
The procedure in the "quick access" mode is described in the following.
Special tools and workshop equipment required
- Wheel Alignment Computer released by VW/Audi
- Vehicle Diagnostic Tester
- Camera :VAS 6331/1 , not illustrated
- Setting Device - Basic Set :VAS 6430/1A