Overview - Data Bus On Board Diagnostic Interface

Courtesy of AUDI

1. Protective Cover
   • Replace after removing
2. Sealing Washer
   • Quantity: 2
   • shared component with the protective cover
3. Antenna Wire Connector
   • Quantity: 2
4. Connector
   • For the Data Bus On Board Diagnostic Interface -J533- - High
5. Connector
   • For the Data Bus On Board Diagnostic Interface -J533- - High
6. Data Bus On Board Diagnostic Interface -J533- - High
   • With Telematics Emergency Battery
   • Emergency Battery, Removing and Installing. Refer to CONNECTED GATEWAY, REPLACING EMERGENCY BATTERY .
   • Removing and Installing. Refer to Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING .
   • Always install with the protective cover
7. Nut
   • Quantity: 2
   • There are different versions. Refer to the appropriate Electronic Parts Information.
   • Replace the self-locking nuts after removing.
   • 5 Nm
8. Data Bus On Board Diagnostic Interface -J533- - Low
   • Removing and Installing. Refer to Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING .
   • Always install with the protective cover
9. Connector
   • For the Data Bus On Board Diagnostic Interface -J533- - Low