Windshield Wiper Assembly Overview: Notes
WARNING: This page is about a different car, the 2024 Audi A6 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Remove cowl panel cover, retaining rail and water deflector for access.
- Wiper blade
- Wiper arm
- Adjusting Fig. 1 Wiper arms, adjusting
- Cover
- Nut, M8
- Tightening torque: 16 Nm (12 ft lb)
- Washer
- Nut
- Tightening torque: 26 Nm (19 ft lb)
- Crank
- Installation position Fig. 2 Wiper motor crank, installed position
- Windshield wiper frame
- Installed with bearings
- Must be replaced as complete unit
- Bearing
- Pressed into wiper frame
- Screw with washer
- Tightening torque: 6 Nm (53 in lb)
- Actuating rod, left
- Pry off
- Coat bearing surface with MoS2 grease
- Wiper motor
Removing:
-- Pry up actuating rods
-- Remove 3 securing screws
- Bolt and washer, for bracket
- Rubber plate
- Bushing
- Screw w/washer
- Tightening torque: 6 Nm (53 in lb)
- Mounting bolt, wiper motor
- Actuating rod, right
- Pry off
- Coat bearing surface with MoS2 grease
- Bracket