Windshield Projection Head Up Display Control Module -J898-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2022 Audi e-tron GT and 2022 Audi RS e-tron GT. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- A control module that has fallen down cannot be used again.
-- When inserting the control module, never apply pressure on the housing upper section.
Installation of a new windshield projection control module
-- Position the bracket -1 and 7- on the control module -4- and tighten the bolts -2 and 6- hand-tight.
-- Insert the control module and tighten the bolts -3 and 5- to the tightening specification.
-- Tighten the bolts -2 and 6- on the bracket to the tightening specification.
Continuation
-- Check the control module function:
Conditions
- A number must be visible on the windshield.