Vehicle, Lifting: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S6, 2022 Audi A6 Quattro, 2021 Audi S6, 2021 Audi A6 Quattro, and 2020 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Using the hoist incorrectly can damage the vehicle.
- Do not exceed the permitted load rating of the hoist.
- Only lift the vehicle at the mounting points shown.
- Position the mounting plate so that it is aligned centrally under the mounting points.
- Maintain distance between the low-lying vehicle components and the hoist.
Procedure:
-- Applies for vehicles with an air suspension ("adaptive air suspension"): before lifting activate vehicle lift mode. Refer to VEHICLE LIFT MODE, ACTIVATING .
-- Applies to the RS models: pull the sill panel reinforcement cover down in direction of -arrow- and remove.
-- Front: place the hoist mounting plate on the raised plastic mounts -arrows- on the bottom of the side sill trim panel.
-- Rear: place the hoist mounting plate on the raised plastic mounts -arrows- on the bottom of the side sill trim panel.
NOTE:
The impressions on the side sill trim panel mark the positions of the mounting points.