Windshield Projection Head Up Display Control Module J898, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

If the windshield projection control module is replaced.

-- For new parts, remove the bolts -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the adjusting element plates -3- from the windshield projection control module -1-.

Continuation for all vehicles

CAUTION:

Risk of destroying the windshield projection control module.

- When inserting, never apply pressure on the housing upper section.

- A windshield projection control module that has been dropped needs to be replaced.

-- Insert the windshield projection control module -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connectors.

-- Tighten the bolts -arrows-.

-- Place the windshield and secure with adhesive tape, but do not bond.

-- Switch the ignition on.

-- Perform a function test.

-- Install the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .

-- Calibrate the windshield projection control module. Refer to Windshield Projection Head Up Display Control Module, Calibrating .

Further installation is performed in reverse order of the removal.