Diagnostic Mode 09 - Request Vehicle Information
Diagnostic Mode 09 makes it possible to access vehicle-specific information from the ECM and the TCM (where applicable).
NOTE:
Depending on scan tool and protocol used, Diagnostic Mode 09 and the information provided may be referred to by a different name.
Test requirement
- No DTCs stored in the DTC memory.
Procedure
-- Connect the scan tool.
-- Switch the ignition on.
-- Select Mode 09: Vehicle information.
-- Select the desired Test-ID.
-- The information requested will be displayed on the scan tool screen.
The following table is a numerical list of all Test-IDs that may be selected.
| Test-ID | Diagnostic text |
|---|---|
| $02: | VIN (Vehicle Identification Number) |
| $04: | Calibration ID |
| $06: | Calibration Verification Number |
| $08: | In-Use Performance Tracking |
| $0A: | ECU's/Module's Acronym And Text Name |
| $12: | Fueled Engine Operation Ignition Cycle Counter |
| $13: | Certification Test Group, Engine Family Number |
| $14: | Distance Traveled Since Evap Monitoring Decision |
| $16: | Vehicle Operation Data - Engine Run/Idle Time |
| $17: | Vehicle Operation Data - Distance/Fuel Used |
| $18: | Vehicle Operation Data - PKE/EOE |
| $19: | Vehicle Operation Data - PSA |
| $1A: | Plug-in Hybrid Vehicle Distance Data |
| $1B: | Plug-in Hybrid Vehicle Fuel Data |
| $1C: | Plug-in Hybrid Vehicle Grid Data |
| $22: | Run Time for Stop-Start and Coasting Off-cycle Credit Vehicle Data |
-- Switch the ignition off.