Overview - Assembly Mounts
WARNING: This page is about a different car, the 2023 Audi S3, 2023 Audi RS 3, 2023 Audi A3 Quattro, and 2023 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- 10 Nm +90°
- Bolt
- 23 Nm
- Bracket
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- 20 Nm +90°
- Bolt
- Replace after removing
- 40 Nm +90°
- Ground Wire
- Only Audi A3 from MY 2021
- Nut
- For OVERVIEW - ASSEMBLY MOUNTS
- 9 Nm
- Bolt
- Replace after removing
- 60 Nm +90°
- Pendulum Support
- There are different versions. Refer to the Parts Information for the allocation.
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS .
- Transmission Mount
- With support arm
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to .
Engine Support - Tightening Specification and Sequence
- Replace bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 3- | 7 Nm |
| 2. | -1 to 3- | 40 Nm |
| 3. | -1 to 3- | 90° additional turn |
Installing the pendulum support
- Replace bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in stages in the sequence shown (example illustration):
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -2 and 3- | 50 Nm |
| 2. | -1- | 130 Nm |
| 3. | -1 to 3- | 90° additional turn |