AWD Vehicles, Checking

Test on a One-Axle Roller Test Stand

• Only check the brakes and the front and rear axle with the "ignition off".
• Only star the engine to create the necessary brake pressure for the brake inspection.
• Then switch off the engine again.

Test Sequence:

• The operation takes place on a test stand.
• For vehicles with manual transmission engage idle.
• On vehicles with automatic or dual clutch transmission select the "N" gear.
• During this test, the wheels of one axle are driven in opposite directions, to prevent delivering power to the other axle.
• The test speed must not exceed 6 km/h (3.73 mph), otherwise the brakes may lock up due to the roller start-up delay (EDL regulation).
• Test stands approved by Audi meet these requirements.