Steering Column, Removing And Installing: Installing
Install in reverse order of removal and note the following:
-- Bring the steering column into the installation position by engaging the mounting hooks -1- on the central tube -2- -arrow-.
Equipment Versions with Anti-Theft Protection Component:
-- Bring the bolt -2- with the anti-theft protection component lower section -1- into the installation position.
-- Tighten the bolts. Refer to Figure.
-- Drive the anti-theft protection component upper section -3- flush into the lower section using a plastic mallet.
Continuation for All:
-- Install the steering intermediate shaft. Refer to STEERING INTERMEDIATE SHAFT, REMOVING AND INSTALLING .
-- Install the steering column switch module. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .
-- Install the driver side instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .
-- Install the driver side footwell vent. Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
- Readapting the end position of the steering gear. Refer to STEERING GEAR END POSITIONS, ADAPTING .
- Calibrate the Steering Angle Sensor -G85-. Refer to Steering Angle Sensor -G85- BASIC SETTING .