Rear Peripheral Camera -R246-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Close the rear lid.
If the Rear Peripheral Camera -R246- was replaced, it must be programmed again prior to calibrating.
Use the Vehicle Diagnostic Tester.
-- Perform a calibration. Refer to PERIPHERAL CAMERA, CALIBRATING .