Ignition Coils, Removing And Installing: Removing

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove and disconnect the connector -2- for the Oxygen Sensor 1 Before Catalytic Converter -GX10- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- If installed, remove the bolt -arrow- and free up the ground wire.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2- and free up the ground wire -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Release the connectors and simultaneously disconnect them from the ignition coils in the direction of -arrow-.

-- Remove the threaded pin -3- for the corresponding ignition coil.

-- Insert the Puller: T10530  in the ignition coil opening -1-.

Fig 1: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC

-- Turn the knurled nut -2- clockwise -arrow- until the puller is clamped.

-- Remove the ignition coil carefully vertically in direction of -arrow- using the Puller: T10530  .

Fig 2: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC