Overview - Assembly Mounts
WARNING: This page is about a different car, the 2022 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Replace after removing.
- Tightening Specifications and Sequence. Refer to Fig 2.
- Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Bolt
- 40 Nm +90°
- Replace after removing.
- Bolt
- 20 Nm +90°
- Replace after removing.
- Bolt
- 40 Nm +90°
- Replace after removing.
- Bolt
- 60 Nm +90°
- Replace after removing.
- Pendulum Support
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing.
- Tightening Specifications and Sequence. Refer to Fig 3.
- Bolt
- Replace after removing.
- Tightening Specifications and Sequence. Refer to Fig 3.
- Bolt
- Replace after removing.
- Tightening Specifications and Sequence. Refer to Fig 3.
- Bolt
- 60 Nm +90°
- Replace after removing.
- Bolt
- 60 Nm +90°
- Replace after removing.
- Transmission Mount
- With support arm
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- 50 Nm + 90°
- Replace after removing.
Engine Support - Tightening Specification and Sequence
- Replace the bolts that were tightened with an additional turn.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening specification/additional turn |
|---|---|---|
| 1. | -1 to 3- | 7 Nm |
| 2. | -1 to 3- | 40 Nm |
| 3. | -1 to 3- | 90° additional turn |
Pendulum Support - Tightening Specifications and Sequence
- Replace the bolts that were tightened with an additional turn.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening specification/additional turn |
|---|---|---|
| 1. | -2 and 3- | 50 Nm |
| 2. | -1- | 130 Nm |
| 3. | -1 to 3- | 90° additional turn |