Gateway Module --, 2021 MY

Component / System	Fault Code (SAE-Code)	Monitor Strategy Description	Malfunction Criteria	Threshold Value	Unit	Secondary Parameters	Enable Condition	Unit	Monitor Frequency of Checks	Monitoring Time Length	Unit	MIL Illum.
Hybrid CAN	U014B	Lost communication with control module for contact-less charging (time out)	Message time out	= detected	[-]	Ignition	= on	[-]	continuous	2, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0112	Lost communication with Battery Energy Control Module "B" (time out)	Message time out	= detected	[-]	Ignition	= on	[-]	continuous	870	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0112	Lost communication with Battery Energy Control Module "B" (time out)	Message time out	= detected	[-]	Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0112	Lost communication with Battery Energy Control Module "B" (time out)	Message time out	= detected	[-]	Driving mode	= active	[-]	continuous	5, 370	[ms]	1 DCY
	U0110	Lost communication with Drive Motor Control Module "A" (time out)	Message time out	= detected	[-]	[(Ignition	= on	[-]	continuous	1, 645	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on
						Driving mode]	= not active
						OR
						Driving mode	= active	[-]	continuous	5, 370	[ms]	1 DCY
	U0110	Lost communication with Drive Motor Control Module "A" (time out)	Message time out	= detected	[-]	(Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on	[-]
						Driving mode	= not active	[-]
	U019B	Lost communication with Battery Charger Control Module "A" (time out)	Message time out	= detected	[-]	Ignition	= on	[-]	continuous	1, 420	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0116	Lost communication with Coolant Temperature Control Module (time out)	Message time out	= detected	[-]	Driving mode	= active	[-]	continuous	370	[ms]	2 DCY
	U0116	Lost communication with Coolant Temperature Control Module (time out)	Message time out	= detected	[-]	Driving mode	= active	[-]	continuous	5, 370	[ms]	2 DCY
	U044C	Invalid data received from control module for contact-less charging	Invalid checksum	≥ 2 consecutive	[-]	Ignition	= on	[-]	continuous	770	[ms]	1 DCY
			OR			OR
			Message counter	≥ 8 repetitions	[-]	Autonomous HV request	= commanded on	[-]	continuous	1, 970	[ms]
	U0413	Invalid data received from Battery Energy Control Module "B"	Invalid checksum	≥ 2 consecutive	[-]	Ignition	= on	[-]	continuous	390	[ms]	1 DCY
			OR			OR
			Message counter	≥ 31 repetitions	[-]	Autonomous HV request	= commanded on	[-]	continuous	680	[ms]
	U0413	Invalid data received from Battery Energy Control Module "B"	Invalid checksum	≥ 2 consecutive	[-]	Ignition	= on	[-]	continuous	1, 370	[ms]	1 DCY
			OR			OR
			Message counter	≥ 5 repetitions	[-]	Autonomous HV request	= commanded on	[-]	continuous	2, 870	[ms]
	U0411	Invalid data received from Drive Motor Control Module "A"	Invalid checksum	≥ 2 consecutive	[-]	(Ignition	= on	[-]	continuous	470	[ms]	1 DCY
			OR			OR
			Message counter	≥ 25 repetitions	[-]	Autonomous HV request)	= commanded on	[-]	continuous	1, 620	[ms]
						Driving mode	= not active	[-]
	U0411	Invalid data signal received from Drive Motor Control Module "A"	Invalid checksum	≥ 2 consecutive	[-]	(Ignition	= on	[-]	continuous	1, 370	[ms]	1 DCY
			OR			OR
			Message counter	≥ 5 repetitions	[-]	Autonomous HV request)	= commanded on	[-]	continuous	2, 870	[ms]
						AND
						Driving mode	= not active	[-]
	U049C	Invalid data received from Battery Charger Control Module "A"	Invalid checksum	≥ 2 consecutive	[-]	Ignition	= on	[-]	continuous	570	[ms]	1 DCY
			OR			OR
			Message counter	≥ 10 repetitions	[-]	Autonomous HV request	= commanded on	[-]	continuous	1, 370	[ms]
	U044C	Implausible signal received from control module for contact-less charging	Wireless HV charging module error state signal	= init	[-]	(Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on	[-]
						Driving mode	= not active	[-]
	U0413	Implausible signal received from Battery Energy Control Module "B"	HV battery current state signal	= init	[-]	Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0413	Implausible signal received from Battery Energy Control Module "B"	HV battery error state signal	= init	[-]	Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0413	Implausible signal received from Battery Energy Control Module "B"	HV battery voltage signal	= init	[V]	Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0411	Implausible signal received from Drive Motor Control Module "A"	HV voltage converter HV side voltage signal	= init	[V]	Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0411	Implausible signal received from Drive Motor Control Module "A"	Power electronics error state signal	= init	[-]	Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U049C	Implausible signal received from Battery Charger Control Module "A"	HV charger current state signal	= init	[-]	(Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on	[-]
						HV charging mode	= active	[-]
						Driving mode	= not active	[-]
	U049C	Implausible signal received from Battery Charger Control Module "A"	HV charger error state signal	= init	[-]	(Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on	[-]

Table continues below

Component / System	Fault Code (SAE-Code)	Monitor Strategy Description	Malfunction Criteria	Threshold Value	Unit	Secondary Parameters	Enable Condition	Unit	Monitor Frequency of Checks	Monitoring Time Length	Unit	MIL Illum.
						Driving mode	= not active	[-]
	U0413	Data bus error value received from Battery Energy Control Module "B"	Information content HV battery	= error	[-]	Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0413	Data bus error value received from Battery Energy Control Module "B"	Information content HV battery	= no component function	[-]	Ignition	= on	[-]	continuous	920	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0413	Data bus error value received from Battery Energy Control Module "B"	Information content HV battery	= service disconnect	[-]	Ignition	= on	[-]	continuous	920	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0413	Data bus error value received from Battery Energy Control Module "B"	Information content HV battery	= interlock	[-]	Ignition	= on	[-]	continuous	920	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0413	Data bus error value received from Battery Energy Control Module "B"	Information content HV battery	= invalid voltage value	[V]	Ignition	= on	[-]	continuous	2, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0411	Data bus error value received from Drive Motor Control Module "A"	Information content HV converter	= invalid voltage value on HV side	[V]	Ignition	= on	[-]	continuous	2, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U049C	Data bus error value received from Battery Charger Control Module "A"	Information content HV charger	= error	[-]	(Ignition	= on	[-]	continuous	5, 370	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on	[-]
						HV charging mode	= active	[-]
						Driving mode	= not active	[-]
	U049C	Data bus error value received from Battery Charger Control Module "A"	Information content HV charger	= no component function	[-]	(Ignition	= on	[-]	continuous	1, 370	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on	[-]
						Driving mode	= not active	[-]
	U049C	Data bus error value received from Battery Charger Control Module "A"	Information content HV charger	= interlock	[-]	(Ignition	= on	[-]	continuous	870	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on	[-]
						Driving mode	= not active	[-]
	U044C	Data bus error value received from control module for contact-less charging	Information content wireless HV charging module	= no component function	[-]	(Ignition	= on	[-]	continuous	2, 370	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on	[-]
						Driving mode	= not active	[-]
	U044C	Data bus error value received from control module for contact-less charging	Information content wireless HV charging module	= interlock	[-]	(Ignition	= on	[-]	continuous	870	[ms]	1 DCY
						OR
						Autonomous HV request)	= commanded on	[-]
						Driving mode	= not active	[-]
	U0411	Data bus error value received from Drive Motor Control Module "A"	Information content power electronics	= interlock	[-]	Ignition	= on	[-]	continuous	870	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0413	Data bus error value received from Battery Energy Control Module "B"	Absolute difference between the voltage measured at HV battery and the HV side voltage measured at voltage converter	> 50	[V]	Ignition	= on	[-]	continuous	3, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
	U0411	Data bus error value received from Drive Motor Control Module "A"	Absolute difference between the voltage measured at HV battery and the HV side voltage measured at voltage converter	> 50	[V]	Ignition	= on	[-]	continuous	3, 370	[ms]	1 DCY
						OR
						Autonomous HV request	= commanded on	[-]
flex ray	U0100	Lost communication with ECM/PCM "A" (time out)	Message time out	= detected	[-]	Driving mode	= active	[-]	continuous	5, 370	[ms]	2 DCY
Gateway internal control module	U0447	Invalid data received from Gateway "A" (EEPROM error)	CASE 1:			none		[-]	once/DCY	500	[ms]	1 DCY
			Read pattern	= not successful	[-]
			Timer	> 5	[s]

			CASE 2:
			Read pattern	= successful	[-]
			Write pattern	= not successful	[-]
			Timer	> 5	[s]
	U0447	Invalid data received from Gateway "A" (RAM error)	Checksum error	= detected	[-]	none		[-]	multiple	5, 000	[ms]	1 DCY
	U0447	Invalid data received from Gateway "A" (ROM error)	Checksum error	= detected	[-]	none		[-]	multiple	5, 000	[ms]	1 DCY
	U0447	Invalid data received from Gateway "A" (watchdog error)	SBC test	= passed	[-]	none		[-]	continuous	5, 000	[ms]	1 DCY
			(External reset	!= detected	[-]
			OR
			Watchdog trigger)	!= reported by the SBC	[-]