Windshield Wiper Assembly Overview: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Audi S6, 2022 Audi A6 Quattro, 2021 Audi S6, 2021 Audi A6 Quattro, and 2020 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Remove cowl panel cover, retaining rail and water deflector for access.
- Wiper blade
- Wiper arm
- Adjusting Fig. 1 Wiper arms, adjusting
- Cover
- Nut, M8
- Tightening torque: 16 Nm (12 ft lb)
- Washer
- Nut
- Tightening torque: 26 Nm (19 ft lb)
- Crank
- Installation position Fig. 2 Wiper motor crank, installed position
- Windshield wiper frame
- Installed with bearings
- Must be replaced as complete unit
- Bearing
- Pressed into wiper frame
- Screw with washer
- Tightening torque: 6 Nm (53 in lb)
- Actuating rod, left
- Pry off
- Coat bearing surface with MoS2 grease
- Wiper motor
Removing:
-- Pry up actuating rods
-- Remove 3 securing screws
- Bolt and washer, for bracket
- Rubber plate
- Bushing
- Screw w/washer
- Tightening torque: 6 Nm (53 in lb)
- Mounting bolt, wiper motor
- Actuating rod, right
- Pry off
- Coat bearing surface with MoS2 grease
- Bracket