Overview - Ignition System
WARNING: This page is about a different car, the 2020 Audi A3, 2019 Audi A3, and 2018 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 8 Nm + 90°
- Always replace after removing.
- The tightening specifications affect function of the knock sensor
- Knock Sensor 1 -G61-
- Removing and installing. Refer to KNOCK SENSOR 1 -G61-, REMOVING AND INSTALLING .
- Spark Plug
- 30 Nm
- Spark Plug Connectors
- Installation position. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Ignition Coil with Power Output Stage
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Bolt
- 10 Nm
- Nut
- 9 Nm
- Bolt
- 9 Nm
- Camshaft Position Sensor 3 -G300-
- Removing and Installing. Refer to CAMSHAFT POSITION SENSOR 3 -G300-, REMOVING AND INSTALLING .
- Perform the adaptation after removing or replacing using the Vehicle Diagnostic Tester 01 - ENGINE ELECTRONICS, FUNCTIONS , 01 - CHAIN LENGTH DIAGNOSTIC ADAPTATION
- O-Ring
- Replace if damaged
- O-Ring
- Replace if damaged
- Camshaft Position Sensor -G40-
- Removing and Installing. Refer to CAMSHAFT POSITION SENSOR -G40-, REMOVING AND INSTALLING .
- Perform the adaptation after removing or replacing using the Vehicle Diagnostic Tester 01 - ENGINE ELECTRONICS, FUNCTIONS , 01 - CHAIN LENGTH DIAGNOSTIC ADAPTATION
- Bolt
- 9 Nm
- O-Ring
- Replace if damaged
- Engine Speed Sensor -G28-
- Removing and Installing. Refer to ENGINE SPEED SENSOR -G28-, REMOVING AND INSTALLING .
- Perform the adaptation after removing or replacing using the Vehicle Diagnostic Tester 01 - ENGINE ELECTRONICS, FUNCTIONS , 01 - CHAIN LENGTH DIAGNOSTIC ADAPTATION
- Bolt
- 4 Nm + 45°
- Always replace after removing.