6.2.2 Retaining Plate for Distance Regulation Control Modules -J428-/-J850-, Removing and Installing

Special tools and workshop equipment required

Removing

Remove the distance regulation control module. Refer to Distance Regulation Control Modules (Removing and Installing)
Place the control module on a soft and clean surface.
Destroy the clips -arrows-.
Remove the retaining plate -2- from the Distance Regulation Control Module - J428-

Installing

Install in reverse order of removal and note the following:

Insert the new clips until they engage in the retaining plate.
Left side of the vehicle: the closed clip -1- must be seated on the bracket -2- at the bottom on the inside.
Right side of the vehicle: the closed clip -1- must be seated on the bracket -2- at the bottom on the outside.
Measure the dimension -a- at all stud bolts using the -VAS6335- and correct if necessary.
- Dimension -a- = 17.6 mm.
Install the retaining plate with the stud bolts on the control module.
- The stud bolt must be aligned correctly to the clip.
Push the stud bolt -1- all the way into the clip -2- as shown.