General Repair Information
WARNING: This page is about a different car, the 2020 Audi A3, 2019 Audi A3, and 2018 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the work area and tools before working on the injection system.
- If the high pressure lines will not be replaced, mark them when removing. The high pressure lines may only be installed again on the same cylinder.
- Align the high pressure lines without tension. First tighten all connections hand-tight and then tighten them again to the tightening specification.
- Never bend the high pressure lines.
- It is permitted to use tools only for tightening and loosening the lines on the entire high pressure system. All other installation or removal procedures must be performed by hand without using any tools.
- All cable ties which are loosened or cut open when removing must be replaced in the same position when installing.
- Fuel hoses in the engine compartment may only be secured with spring clamps. The use of clamps or screw-type clamps is not permitted.