11.7.2 Peripheral Camera System, Calibrating
- The vehicle must be on a level surface.NOTE: The vehicle in the illustration is only a basic outline.
- Roll out the Calibration System - VAS 721 001- at the left and right near the vehicle.
- Install the rear and front clamping strips on the Calibration System - VAS 721 001-.
- Align the crosshairs -2- to the front axle of the vehicle (center front wheel).
- Align both calibration devices parallel. The vehicle must be located in the center between both calibration devices.
Pay attention to the following measurement requirements:
- Dimension -a- 2000 to 2500 mm ± 5 mm, front and rear the same
- The dimension -b- must be the same on both sides
- The dimension -c- must be the same on both sides
- Set-up the requirement for the vehicle. Refer to
- Connect the Vehicle Diagnostic Tester.
Calibrating Procedure
- Select the Diagnostic mode and start the diagnosis.
- Select the Test plan tab.
- Select the Select individual test
button and select the following tree structure consecutively:
- Body
- Electrical system
- OBD-capable systems
- 6C - peripheral camera control module | J928
- 6C - peripheral camera control module, functions
- 6C - Calibration, (Repair Group 91)
From here, the Vehicle Diagnostic Tester advances the calibration procedure forward.