Diagnostic Mode 02 - Read Operating Conditions: Procedure
-- Connect the scan tool.
-- Start the engine and run at idle.
NOTE:
If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch the ignition off afterward.
-- Select "Diagnostic Mode 2: Obtain operating conditions".
-- From the following table, select the desired "PID". "PID $05 Coolant Temperature" that is to be monitored.
The current values of the component or system that is being monitored will be displayed on the scan tool screen.
| PID | Component or System |
|---|---|
| $00: | Supported definition pids, $01 - $20 |
| $02: | Fault code that caused the freeze frame to be stored |
| $03: | Fuel system status |
| $04: | Calculated load value |
| $05: | Coolant temperature |
| $06: | Oxygen sensor integrator |
| $07: | Oxygen sensor adaptation value |
| $0B | Intake Manifold Pressure |
| $0C: | Engine speed |
| $0D: | Vehicle speed |
| $0E: | Firing angle |
| $0F: | Intake air temperature |
| $10: | Air mass flow |
| $11: | Throttle 1, sensor 1, throttle position absolute |
| $1F: | Time after engine start |
| $20: | Supported definition PIDs $21 - $40 |
| $23: | Intake air temperature (IAT) |
| $2E: | Control tank ventilation valve |
| $2F | Tank level |
| $33: | Ambient pressure |
| $40: | Supported definition PIDs $41 - $60 |
| $42: | Control module voltage |
| $43: | Absolute load factor |
| $44: | Lambda desired value |
| $45: | Butterfly valve position relative |
| $46: | Ambient temperature |
| $47: | Butterfly valve position 2 absolute |
| $49: | Driving pedal position 1 absolute |
| $4A: | Driving pedal position 2 absolute |
| $4C: | Butterfly valve target position |
| $51: | Fuel type |
| $56: | Offset oxygen sensor regulation after catalytic convertor |
| $60 | Supported definition PIDs $61 - $80 |
| $67: | Coolant temperature |
| $70 | Turbocharging |
-- Switch the ignition off.