Monitor-ID $71: Secondary Air System
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 06: Check / test the results of components that are not continuously monitored".
Select "Monitor-ID $71".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $82 | P0491 | Flow Check. | 0.10 - 0.53 - 0.55 | 1.99 | Refer to DTC P0491 in the DTC summary table.Engine Control Module --, 2020 MY => P0491 |
| $85 | P0410 | Pressure Check. | 0.0 kPa | 2.0 kPa | Refer to DTC P0410 in the DTC summary table.Engine Control Module --, 2020 MY => P0410 |
| $8C | P2440 | Tightness Check | 0.0 | 1.39 | Refer to DTC P2440 in the DTC summary table.Engine Control Module --, 2020 MY => P2440 |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic Mode 03: Interrogating Fault Memory to check for stored DTCs or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.