Bevel Box, Installing
WARNING: This page is about a different variant/trim than selected.
Procedure
Install in the reverse order of removal while noting the following:
-- Place the bevel box with the right flange shaft on the transmission while turning the flange shaft at the same time.
-- Tighten the bevel box on the transmission.
-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .
-- Gear Oil, Checking Level. Refer to GEAR OIL, CHECKING LEVEL .
Tightening Specifications
- Refer to OVERVIEW - BEVEL BOX
- Refer to BEVEL BOX, TIGHTENING SPECIFICATION
- Refer to OVERVIEW - DIFFERENTIAL
- Refer to OVERVIEW - SUBFRAME MOUNT .
- Refer to OVERVIEW - DRIVE AXLE .
- Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .
- Refer to OVERVIEW - LOWER CONTROL ARM AND BALL JOINT .
- Refer to appropriate service information. .
- Refer to OVERVIEW - NOISE INSULATION .