There are Two Choices for the Basic Setting:

The "Complete Alignment"

This procedure must be selected for the following activities if a wheel alignment and basic setting should be performed.

The rear axle toe was adjusted.
The vehicle suspension was changed, for example changing from standard to sport suspension.

The "Quick Access"

This procedure should be selected for the following activities if only the basic setting will be performed.

NOTE:

Both procedures are programmed in the wheel alignment computer. The respective procedure is performed automatically. It is only necessary to select the appropriate program for the procedure that will be performed.
If the basic setting should be performed, then the "quick access" mode must be selected.
The procedure in the "quick access" mode is described in the following.