Pinpoint Test I : The RF Tweeter Speaker Is Inoperative
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- I1 CHECK THE RF DOOR SPEAKER
- Ignition ON.
- Operate the audio system in AM/FM mode.
Does the RF speaker operate correctly?
Yes GO to I2. No GO to Pinpoint Test G . - I2 CHECK THE AUDIO SIGNAL TO THE RF TWEETER SPEAKER
- Ignition OFF.
- Disconnect: RF Tweeter Speaker C613 .
- Ignition ON.
- Operate the audio system in radio tuner AM/FM mode.
Is a fluctuating AC voltage present?
Yes INSTALL a new RF tweeter speaker. REFER to Speaker - Door . No GO to I3. - I3 CHECK THE AUDIO CIRCUITS TO THE RF TWEETER SPEAKER FOR A SHORT TO VOLTAGE
- Ignition OFF.
- Disconnect: RF Door Speaker C612B .
- Ignition ON.
Is any voltage present?
Yes REPAIR the circuit in question. No GO to I4. - I4 CHECK THE AUDIO CIRCUITS TO THE RF TWEETER SPEAKER FOR A SHORT TO GROUND
- Ignition OFF.
Are the resistances greater than 10, 000 ohms?
Yes GO to I5. No REPAIR the circuit in question. - I5 CHECK THE AUDIO CIRCUITS TO THE RF TWEETER SPEAKER FOR AN OPEN
Are the resistances less than 3 ohms?
Yes GO to I6. No REPAIR the circuit in question. - I6 CHECK THE AUDIO CIRCUITS TO THE RF DOOR SPEAKER FOR A SHORT TOGETHER
Is the resistance greater than 10, 000 ohms?
Yes GO to I7. No REPAIR the circuits. - I7 CHECK FOR CORRECT ACM OPERATION
- Ignition OFF.
- Disconnect and inspect the ACM connector.
- Repair:
- Corrosion (clean module pins or install new connectors or terminals)
- Damaged or bent pins (install new terminals or pins)
- Pushed-out pins (install new pins as necessary)
- Reconnect the ACM connector. Make sure it seats and latches correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no TSBs address this concern, INSTALL a new ACM. REFER to Audio Control Module (ACM) . No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.