Steering Gear, Removing And Installing: Installing
Install in reverse order of removal. Note the following:
-- Install both bolts -1 and 2- loosely at first and then tighten them.
WARNING:
Pull on the steering intermediate shaft -1- to make sure it is secure when the bolt -arrow- is installed. Then tighten the bolt -arrow-.
-- Install the stabilizer bar. Refer to STABILIZER BAR, REMOVING AND INSTALLING .
-- Install the crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .
The "program" J500 Replace Control Module must be started in Guided Fault Finding on the Vehicle Diagnostic Tester if new electromechanical steering gear is installed.
-- Perform an axle alignment. Refer to VEHICLE ALIGNMENT .