Front Level Control System Sensor -G78- / -G289-, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2017 Audi A3, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Installation is the reverse of removal, with special attention to the following:
NOTE:
The level control system sensor lever must point toward vehicle exterior.
The thread on the level control system sensor must be installed in the front hole in the control arm. The tab on the level control system sensor must fit into the rear hole to assure that the installation position is correct.
On vehicles with level control system sensor if the coupling rod from the level control system sensor was removed of a level control system sensor was remove and reinstalled or replaced:
- "Re-adapt control position". Refer to Vehicle Diagnostic Tester.
- On vehicles with lane assistance calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
- Evaluate the need for a basic setting of the headlamps. Refer to HEADLAMP, ADJUSTING .