Overview - Ignition System
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 8 Nm + 90°
- Always replace after removing.
- The tightening specifications affect function of the knock sensor
- Knock Sensor 1 -G61-
- Removing and installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Spark Plug
- 30 Nm
- Spark Plug Connectors
- Ignition Coil with Power Output Stage
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Bolt
- 10 Nm
- Nut
- 9 Nm
- Bolt
- 9 Nm
- Cam Position Sensor 3 -G300-
- Removing and installing. Refer to Cam Position Sensor 3 -G300-, REMOVING AND INSTALLING .
- O-Ring
- Always replace if damaged
- O-Ring
- Always replace if damaged
- Cam Position Sensor -G40-
- Removing and installing. Refer to Cam Position Sensor -G40-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Always replace if damaged
- Engine Speed Sensor -G28-
- Check the O-ring for damage
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 4 Nm + 45°
- Always replace after removing.