Rear Peripheral Camera -R246-, REMOVING AND INSTALLING: Removing

-- Turn off the ignition and all electrical equipment and remove the ignition key.

The Rear Peripheral Camera -R246- has a trailing cable. The vehicle wiring harness couplings are located in the rear lid.

-- Remove the lower rear lid trim panel. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .

-- Release and disconnect the connectors -3 and 4- from the rear lid handle button.

Fig 1: Releasing And Disconnecting Connectors -3- And -4- From Rear Lid Handle Button

Courtesy of AUDI OF AMERICA, LLC

The Rear Peripheral Camera -R246- -1- is permanently attached to the handle button.

-- Remove the nuts -2 and 5-.

-- Pull the handle button with the Rear Peripheral Camera -R246- -1- out of the holder in the rear lid; while doing so, press the right and left locking tabs.