Steering Wheel, Removing And Installing: Removing
Applies To Vehicles Equipped With Dynamic Steering:
Before The Steering Wheel Can Be Removed From The Steering Column, The Steering Wheel Must Be In The Exact Horizontal Using The :Vas6458 . Mount The New Steering Wheel So That It Is Horizontal Using The :Vas6458 .
After Doing This Step, The Steering Angle Sensor -G85- For Setting The Steering Wheel Position Must Be Checked. While Doing This, Select The Appropriate Measured Values Block In The Steering Column Electronics Control Module -J527- In On Board Diagnostics. If The Displayed Value Is > 0.5°, Then The Steering Angle Sensor -G85- Must Be Calibrated Again And The Dynamic Steering Must Be Adapted, By Starting The Correct Program Using The Vehicle Diagnostic Tester In Guided Functions .
-- Straighten The Wheels.
-- Position Steering Wheel As Far Back As Possible. Use Entire Steering Column Adjustment Range To Do This.
-- Remove The Driver Side Airbag. Refer To Airbag Unit With Igniter, Removing And Installing .
Removal And Installation Of Steering Wheel Must Take Place In Center Position (Wheels In Straight-Ahead Position).
-- Remove The Bolt -1-.
-- Mark Position Of Steering Wheel/Column With A Felt-Tip Pen.
-- Remove Steering Wheel -2- From Steering Column.