LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A4 Prestige >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Generic Scan Tool [CYMC,DJYA,DPAA] (General INFOAMATION) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions >> Monitor-ID $A5: Mis-Fire Cylinder 4 Data

Monitor-ID $A5: Mis-Fire Cylinder 4 Data

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Diagnostic Mode 06: Check / test the results of components that are not continuously monitored" .

Select "Monitor-ID $A5" .

-- Select the desired "Test-ID" .

-- Check specified values at idle.

Test-ID (TID) (Hex-ID) DTC Component or System Min. Max. Additional Information
$0B P0304 Misfire Cylinder 4, Average Value Over 10 Driving Cycles. 0.0 counts 65,535.0 counts Refer to DTC P0304 in the DTC summary table.Engine Control Module -- P0304
$0C P0304 Misfire Cylinder 4, In This Driving Cycle. 0.0 counts 65,535.0 counts Refer to DTC P0304 in the DTC summary table.Engine Control Module -- P0304

-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals