Monitor-ID $35: Cam Shaft Adjustment
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 06: Check / test the results of components that are not continuously monitored" .
Select "Monitor-ID $35" .
-- Select the desired "Test-ID" .
-- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $80 | P0011 | Target Check Intake. | 0.0° CRK | 10.0° CRK | Refer to DTC P0011 in the DTC summary table.Engine Control Module -- P0011 |
| $81 | P000A | Slow Response Intake. | 0.0° CRK | 1.49° CRK | Refer to DTC P000A in the DTC summary table.Engine Control Module -- P000A |
| $82 | P0014 | Target Check Outlet. | 0.0° CRK | 10.0° CRK | Refer to DTC P0014 in the DTC summary table.Engine Control Module -- P0014 |
| $83 | P000B | Slow Response Outlet. | 0.0° CRK | 1.49° CRK | Refer to DTC P000B in the DTC summary table.Engine Control Module -- P000B |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.