Diagnostic Mode 09 - Read Vehicle Information
Diagnostic Mode 09 makes it possible to access vehicle specific information from the control modules (where applicable).
NOTE:
Depending on the scan tool and protocol used, Diagnostic Mode 09 and the information provided may be referred to by a different name.
Test Requirement
- No DTCs stored in the DTC memory.
Procedure
-- Connect the scan tool.
-- Switch the ignition on.
-- Select Mode 09: Vehicle information.
-- Select the desired Test ID.
-- The information requested will be displayed on the scan tool screen.
The following table is a numerical list of all Test IDs that may be selected.
| Test-ID | Diagnostic text |
|---|---|
| 00: | Supported InfoTypes $01-$20 |
| 02: | Vehicle identification number |
| 04: | Calibration identification |
| 06: | Calibration Verification Numbers CVN (check sum) |
| 08: | In-use Performance Tracking Information (IPT - Counter) |
| 0A: | ECU Name |
| 14: | Distance Traveled Since Evap Monitoring Decision |
| 16: | Vehicle Operation Data - Engine Run/Idle Time |
| 17: | Vehicle Operation Data - Distance/Fuel Used |
| 18: | Vehicle Operation Data - PKE/EOE |
| 19: | Vehicle Operation Data - PSA |
| 20: | Supported InfoTypes $21-$40 |
| 22: | Run Time for Stop-Start and Coasting Off-cycle Credit Vehicle Data, not for MQ |
| 24: | Active Powertrain Warm-up Features Off-cycle Credit Vehicle Data |
-- Switch the ignition off.