Front Brake Caliper: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Using 2 new copper washers, position the brake flexible hose on the brake caliper and install the brake caliper flow bolt.
- Tighten to 40 Nm (30 lb-ft).

2.

NOTE: Tighten the lower caliper guide pin bolt first.

Position the brake caliper on the brake caliper anchor plate and install the 2 guide pin bolts.
- Tighten to 37 Nm (27 lb-ft).

3.

Bleed the brake caliper. For additional information, refer to Component Bleeding in Brake System General Information .

4.

Install the wheel and tire. For additional information, refer to Wheels and Tires .