6.2.1 Distance Regulation Control Module -J428-/Distance Regulation Control Module 2 - J850-, Removing And Installing
NOTE:
If replacing the control module, select the "Replace Control Module" function using the Vehicle Diagnostic Tester.
Removing
- Remove the air intake grille. Refer to Body Exterior (Front Bumper; Attachment, Removing and Installing).
- Unclip the cover.
- Remove the bolts -1 to 4-.
- Remove the distance regulation control module -A- from the bumper cover.NOTE: Clean and dry the area around the control module connector.
- Disconnect the connector -arrow-.
Installing
Install in the reverse order of removal. Note the following:
NOTE:
Check the connector for damage, contact corrosion and water ingress, and service if necessary. Refer to Electrical Equipment General Information (Wring Harness and Connector Repair).
- Calibrate the adaptive cruise control. Refer to 6.3 Adaptive Cruise Control, Calibrating.
Tightening Specifications